|
|
|
HOW TO INSPECT GD&T SPECIFICATIONS
Someone had the bright idea of putting GD&T symbols all over
your drawings, now what do you do? How about learning how
to inspect each of these ASME Y14.5 specifications? We can show
you how in this straightforward, practical course.
This two-day GD&T course is designed specifically to present the
information to properly interpret and verify each of the 14
geometric characteristic symbols. |
|
TARGET
AUDIENCE
|
|
COURSE LENGTH AND COST
|
|
This program is designed for anyone who is responsible for
measuring part features, or for interpreting the results of
measurements from the metrology department. This is not
specific to any particular measurement software package. A.G.I.
strongly recommends Fundamentals of GD&T and Advanced GD&T as
prerequisites for this course, or the permission of the
instructor. |
 |
Length: 2 days
Time: 8:00 a.m. - 4:30 p.m.
Please see our
public training schedule
for prices, dates and locations.
Register
|
|
WHAT’S
COVERED
|
OBJECTIVES:
- Review the concepts of the Y14.5M standard
- Expand the participants’ knowledge of the concepts and the
language of the Y14.5M standard as it pertains to inspection
- Make practical use of software, hardware, and measurement
philosophies
- Develop "work-arounds" to overcome potential measurement
uncertainties
PROGRAM OUTLINE:
The program begins with a review of GD&T. We then continue with
practical evaluation of measurement philosophy and capabilities,
as well as pitfalls. The subject matter
covered is (as a minimum):
- Introduction -- Objectives, review GD&T
- Metrology -- concepts, philosophy, practice, and
misconceptions
- Measurement software -- what is being calculated per the ASME/ANSI
Y14.5M standard and what is not
- Effects of Datum features of size
- "Shortcuts" you can take, and those that you cannot
- Review of actual prints (participant and instructor
supplied)
 |
Register
Back to Training Page
Back to Schedule
|
|
